Haha. Too much maintenance for a business rig. Maybe next time I make lots and lots of "bank."
I'll probably get a CPU 8 pin extender (I assume they make them). That was the one PSU run that was not long enough. That way I can close that divider back up between the lower and upper chamber. This was obviously mid-build, as I don't have those updated full case pictures up. I didn't even take one of it fully completed as it was soooo late when I got done. The cable management on this case is quite good. Would have maybe liked to see a little more room behind the motherboard, as it took some patience to get the wires tied up tight enough to not be squashed. But, there's no window so a few that are showing won't hurt. The main ones are out of the way for good airflow. I'll probably pick up two 140mm for the front so they are the same. But that can happen way down the road because I'll have to rig up my fan controller again by splicing that top 180mm into the on/off switches so I can control both front 140's independently. That's what sucks about a 4 pot, 2 switch fan controller...haha. It was only $30 though, so it'll do for now.